Phoca Forum

I've installed and activated Phoca maps plugin successfully, it is appeared in "Components" and so on. I also create map and can create menu item and map is appeared ok via it but when try to use codes provided by plugin or in standard articles it is appeared as plain text instead of map.
What problen could it be? I have a 2.5 joomla.
Thanks in advance for any input!

Hi, text is displayed only in two cases:

- the plugin is not installed
- or the plugin is not published.

Jan

Hi,

I have the same problem.
I installed and published/enabled the plugin but only the text is displayed. :/

Hi, then check all the version - of your Joomla!, component and plugin and let me know them. As written above, there are only two cases when the text is displayed instead of running code:

- the plugin is not active
- the plugin is not installed

and specific case:
- the plugin was not set in content (article) (in case you didn't use content plugin in content)

Jan

Hi, thank you for your answer.

Indeed, I set the plugin in a module. Is there anyway to display it ?

Hi, then it depends on the place where you are displaying it - you need to set it correctly to display plugin correctly.

See:
https://www.phoca.cz/documents/16-joomla ... t-articles (as example)

Works fine, thanks !!

Ok

Hi
I have same problem.
But i also tried to add code :
{phocamaps view=map|id=1} or {phocamaps view=link|id=1|text=Map}
in an article & then make a link to it but article shows text code again.
What's problem?
Thanks

@alirezate,
which joomla! version, which Phoca Maps Component version & which Phoca Maps Plugin version do you use?

Kind regards,
Benno